Tweet
Hey Guys,
Quick question. I have 2> 30AMP HobbyKing ESC's that I am running on a twin setup (1500KV motors) with 2> 2200 3S Lipo packs. Going to connect them into a Y harness to the receiver.
If I use the BEC option in the ESC, would I need to disable the red wire on one of the ESC's so that I don't get double the load back to the receiver?
Not sure if it matters or not. Just don't want to fry my receiver.
Thanks!
Quick question. I have 2> 30AMP HobbyKing ESC's that I am running on a twin setup (1500KV motors) with 2> 2200 3S Lipo packs. Going to connect them into a Y harness to the receiver.
If I use the BEC option in the ESC, would I need to disable the red wire on one of the ESC's so that I don't get double the load back to the receiver?
Not sure if it matters or not. Just don't want to fry my receiver.
Thanks!
Comment