Yesterday after club races while waiting for others to finish upon rethrottle to come in ESC blew so hard it lifted the lid off. Now after installing new esc nothing works. I installed and bound new receiver and motor runs but no servo, can a badly blown esc take out these other parts as well. ESC was in 3 pieces and light in old receiver did not come on when new ESC was plugged in. Thanks for the help.
Blown T180
Collapse
X
-
One possible (and likely) explanation is that when the ESC went kaboom it shot the full input battery voltage (normally detoured through the bec circuit) to the Rx and servo, burning them up. I've had that happen when outboard bec's did the same.
A handy tool for testing servo's :
DSC07654.JPG
Start saving up your $$ to buy one:
2008 NAMBA P-Mono & P-Offshore Nat'l 2-Lap Record Holder; '15 P-Cat, P-Ltd Cat 2-Lap
2009/2010 NAMBA P-Sport Hydro Nat'l 2-Lap Record Holder, '13 SCSTA P-Ltd Cat High Points
'11 NAMBA [P-Ltd] : Mono, Offshore, OPC, Sport Hydro; '06 LSO, '12,'13,'14 P Ltd Cat /Mono
Comment