not sure

[launchpad]

hello out there.Presently I am in the process of twinning the Genesis boat.I have two 2200kv 3674 leopard motors and two Turnigy 90amp esc,s.Does anyone know how I would go about programming them.Do I program one at a time or can I do both the same time,probably not!Ice is melting off the lakes and I would like to get this on the water.Can anyone assist me.
Thankyou

[srislash]

One at a time. Calibration too though some have done calibration collectively.

[launchpad]

esc setup

One at a time. Calibration too though some have done calibration collectively.

Thanks........one person told me that I have to cut the red wire on one because with two draws from both Esc.Have you any experience with this type of setup and how did it work out? Thankyou

[srislash]

Oh yes if you are going to run the internal BEC from one then remove the Red wire from the others connector. Put a bit of heat shrink over the pin that was removed. But do this after you have programmed and calibrated that ESC.

Don't cut that red wire for it will create a hassle later if further programming is required. Just remove from the connector, it is easily done with say a exacto knife. Just lift the little plastic tab and pull pin.

[srislash]

Btw, I am currently building a very similar setup, Daytona with 2650kv's for 3s

[launchpad]

not sure

Oh yes if you are going to run the internal BEC from one then remove the Red wire from the others connector. Put a bit of heat shrink over the pin that was removed. But do this after you have programmed and calibrated that ESC.

Don't cut that red wire for it will create a hassle later if further programming is required. Just remove from the connector, it is easily done with say a exacto knife. Just lift the little plastic tab and pull pin.

Thanks,glad you told me about that.Ok now I have to find the time for this................