Phoniex Ice lite how to program with a spektrum radio

[fas]

Just like it says I have a ice lite and I am trying to use it with a spectrum dx3s,

I have tried every thing I can think of to get it to arm with out using a pistix any help would be great

Fred

[jantagg]

If it is an airplane controller try setting the Sub-Trim to B100 and the Sub Trim to B50.

[Fluid]

You will want to set these features to the lowest setting:

Travel: Brake to 150%
Menu Sub Trim: -100%
Sub Trim by Wheel: B50

It should work now.

.

[Alexgar]

Jay will this work with all airplane controllers on my spektrum dx3c

[oscarel]

This may also work, works with Futaba:

change the 'Throttle Type' to Fixed-Endpoints and follow the instructions in Castle-Lync.

Fixed-Endpoints
Fixed-Endpoints will set zero-throttle and full-throttle points to fixed values so that the ESC does not have to learn from your transmitter. If you are using this mode, you will most likely want to change the EPA settings on your transmitter to allow full throttle resolution with the throttle stick. *!**To do this, turn on your TX and set normal mode in the transmitter for a linear throttle curve (0,25,50,75,100). Bring your high side and low side endpoints on your throttle channel down to 25%, plug in the battery pack with the throttle stick at full (it won't start up), then bring your high endpoint back out towards (and sometimes past) 100% until you hear a single tone. Next, bring your throttle stick down to the bottom position and bring the endpoint out from 25% out towards (and possibly past) 100% until you hear the ESC arm. Unplug the battery pack, wait a few seconds, then plug back in and verify that the throttle is working properly.

[Fluid]

Jay will this work with all airplane controllers on my spektrum dx3c

I do not know, the only ones I have tried have been Castles.


.

[fas]

Thanks Jay works like a charm

Fred