castle hydra ice hv200 waterproofing

[meangenesracing]

on my third one last two burnt up got alot of tips from some great people here on this forum. im in the process of changing my prop to a smaler one, lifting the strut, removed about 20 inches of battery wire. i dont believe the esc is getting wet but i got some corroision x on the way what will be the best way to apply this should i just soak it in a glass full or just remove the plastic covers and spray it down very good anybody out there done one of these castle hv200 thanks for any help, geno

[mudn_1]

Yeah i just dip my esc's, rx's etc. For about 10 or 15 mins and pull it up then repeat after 24hrs.....i just did an ipod docking station that i take to the beach every year, well last year it quit....so ill let tou know how it goes this year after corrosion x

stupid phone

[oscarel]

I sprayed my ice with the corrosionx HD, its thicker and is suppose to stick longer. So far its working. I sprayed from the cap end until it came out the other. I bought it from academy sports.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

[HydroMike]

This is better then that might want to look into this http://forums.offshoreelectrics.com/...ht=#post415457

[oscarel]

Have you tried it? Not sure a receiver is proof, the Flysky receivers can be dunked without coating and they survive.

[HydroMike]

If u look on there he does a test with a 110 light bulb and holds it in with his hand but yes I have done some testing and it works great so far