New Turnigy ESC

[Jeff Wohlt]

And......back to this post. At least a program module! the shrinkwrap???...I think I can handle that mod.

[alvinsmith75]

I just got a new 240 also and neither size tubing that I got from OSE seems to be able to fit. The tubes are too close together. What is the secret?

I usually use saliva lube and slide both lines on at the same time. You can also use a small screwdriver or allen wrench and slide it in the tube and carefully pry them apart.

[bustitup]

I just got a new 240 also and neither size tubing that I got from OSE seems to be able to fit. The tubes are too close together. What is the secret?

its very easy but be very carefull

slid something into the tubes (the same size as the inside diameter of the tube) and very carefully bend it to the side just slightley

if you were to mark them 1 2 3 4

bend 1 and 2 to the left and 3 and 4 to the right.....you dont need much bned to be able to slide the fuel tubing on so bend very little its easy

[bustitup]

that my freinds looks like they added water cooling and upgraded the old hextronic esc...it also programs with a usb thingy and was a very very good esc

http://www.hobbyking.com/hobbycity/s...rogrammability

[hide]

For the watercooling tubing I used silicone lube spray on both the pipes and the tubing, worked a treat, was really struggling with them prior to that.

[sundog]

I'm not too crazy about having just one water tube along one side - like the Etti 150A non-opto (w/bec). Just doesn't seem like it will be as efficient as two - how many cents would another tube have cost them? It cost Etti another repair when mine fried a while back. Methinks they should go back to two tubes like on their opto model.