Tweet
Can a Etti 150 2-7 lipo withstand SAW runs with a 1527 1d motor in a hydro on 6s ? It says 300 amp burst but for how long i dont know.
-
PT-45, 109mph, finally gave up after last bad crash
H&M 1/8 Miss Bud 73 mph
Chris Craft 16 mph -
I would think so. I am running a dual setup with Etti 150's and Turnigy 2300kv 36mmx56mm motors on 5S and it barely breaks 100*F after some hard runs...The RTR Nightmare- Electric King of Shaves
Now with 540s- 62mph
New setup- Etti 150A's, Turnigy 2600s, 5S, X442s and a whole lot of cooling hoses -
It'll depend directly on the size of your prop.
But it's a pretty tall order for most ESCs... SAW passes, if done in SAW fashion will
take a lot from your equipment, regardless of what you have.:::::::::::::::. It's NEVER fast enough! .:::::::::::::::Comment
-
I know but im just trying to find an ESC that will not smoke on plugin LOL . Thats a tall order these days !!!!!!!!!LOL My Hydras would last 30-40 passes now i get 2-6 if they even get off the bench from the programing mode. I was even looking at a turnygy 200 amp 2-12s unit for $189.00. It looks pretty good but has no water cooling but that shouldnt matter on short runs i would think. Like i said i do things right and it kicks sand in my face so its time to try off brand stuff i think. My SAW boat has been parked for almost 7 weeks now. This sucks.PT-45, 109mph, finally gave up after last bad crash
H&M 1/8 Miss Bud 73 mph
Chris Craft 16 mphComment
Comment