wath means wen only the wires and bateries hot and the motor e esc continuous cold

[Joselindo Oliveira]

hi mi name is joselindo im new here i dont find the presentencion blog, so i have my rc genesis with a leopard 4092 1730kv and a turnigy 180A with two 3s lipo 4.400 65C and 45 propler and the motor stays cold and the esc too ist only the wire warm up and a litle of the bateries can someone tell me why? tanks in advance

[Luck as a Constant]

Bad solder joints most likely


Sent from my iPhone using Tapatalk

[Joselindo Oliveira]

tanks i will try make a new solder for test again tanks a lot

[Luck as a Constant]

Well it's just my guess.
Hope it helps!


Sent from my iPhone using Tapatalk

[Joselindo Oliveira]

i will try

[kevinpratt823]

If you only have (2)x 3s/4400mah, it sounds like you are a bit low on battery power/capacity. That is a big motor, running pretty high rpms, that sounds like a high demand for 6s/4400mah.

[Joselindo Oliveira]

If you only have (2)x 3s/4400mah, it sounds like you are a bit low on battery power/capacity. That is a big motor, running pretty high rpms, that sounds like a high demand for 6s/4400mah.

hi, i use 2 bat 3s 4.4mha 65c nanotech bateries in serie, so did you mean i need use 2 bat 6s in parallel ? tanks

[kevinpratt823]

hi, i use 2 bat 3s 4.4mha 65c nanotech bateries in serie, so did you mean i need use 2 bat 6s in parallel ? tanks

You don't HAVE to, but I personally think it would be a lot better.

Sent from my SCH-I535 using Tapatalk 2

[Joselindo Oliveira]

i will try with 2 bat 3s 8400mha in seires and with 2 bat 6s 5000 in parallel for the next weekend and i post here waths appens, tanks

[kevinpratt823]

You could post a picture of your setup and it may help. What prop? what connectors?

[Joselindo Oliveira]

IMG_2053[1].jpgIMG_2055[1].jpgIMG_2056[1].jpgthis my genesis with turnigy 180A and 2 3s bat in series and prop octura m445

[Make-a-Wake]

What guage are your ESC motor wires? What type of connectors do you have, they need to need 5.5mm gold minimum.

[kevinpratt823]

If wires keep getting hot, you could upgrade to bullets for batt connectors, and shorten the motor wires on the esc, (not the ones on the motor). Also, you should turn the cooling jacket so the water comes out at the very top of the motor, so the jacket fills ftom the bottom and purges all the air out.

Sent from my SCH-I535 using Tapatalk 2

[Joselindo Oliveira]

in motor is Leopard 6.0mm male bullet plugs but in my bateries i have 4mm and the esc wires is 10 awg and the motor wire is the original wire i gess the same size

[Make-a-Wake]

Good eye Kevin, he needs to turn the jacket so that the nipple is on top on the rear end of the motor.