cat biuld

[zanda]

i am going to glass the hull as im not happy with just epoxy resin strenght i no i could use 2 pac areldite but i could not paint it on the hull as it was to thick and hard to sand more so than fiber glass.

UNLESS

im not sure if you can thin areldite to make it easyer to apply with a brush any idea if this is posabble?

[peells]

Zanda here is a parallel connector I made, this is before I epoxied over the bus bars which make the parallel connection. I was looking for the finished connector but I have had a big weekend here in Northern California and gave up looking for it. The best setup for this hull is Twin screws the handeling is awesome, I just ran the Bob kat this weekend and it pulls to one side and likes to turn counter clockwise. (it is a Single, The double is on the construction board) have them rotate inward it wont favor turning one direction over the other and will handle great.

Pete

[zanda]

finished glassin sanding bogging more sanding and started the under coat . thank god i dont have to sand any more!!!!!!!!!!!

[peells]

Lets see whatcha got now, Two screws work extremely good, counter rotating to the inside, it will steer like a dream, run 2-3s in parallel, check out HK's site they have a lot to choose from

[zanda]

Lets see whatcha got now, Two screws work extremely good, counter rotating to the inside, it will steer like a dream, run 2-3s in parallel, check out HK's site they have a lot to choose from

whats HK's site?

[peells]

hobbyking.com

[zanda]

1st under coat

[zanda]

shes now a green machine . im a little anoyed that the paint ran when i painted the window but its almost there , i dont think i will do much more to the hull . keeping it simple.

[zanda]

put the motor mounts in today and solded up my wires which can i say is a pain in the arse. but i got there. i have put almost all my wireing up the front deck so there is heaps of room for my batterys.

[peells]

Have you tested your wiring harness?

[CornelP]

So you have two batteries in series with 2 ESC in parallel?

[peells]

Do you know the size of the cans on your motors? 36X56 you should get some kind of water cooling for them going on your esc's get 2 little computer fans for them and screw them right down on the cooling fins of the esc's and tap your power right off the connection on the esc board where the batteries come in at, we have found that a couple of 440 screws will fit the fin spacing, on other esc's but it works great if they are car type esc's which is what it looks like you are running, don't forget to use hatch tape you do not want any water getting in there esc's are expensive to be drowning.

[ace028]

Looks like its going to be crazy fast!!!!!

[zanda]

Have you tested your wiring harness?

i have tested the wiring and it works the only problem is that both moter are spinning the same direction so i will have to work something out with that .

[zanda]

So you have two batteries in series with 2 ESC in parallel?

i just followed what your diagram said . i will try both having one battery for one esc as well.