Hello all. New to the forum and boat building. Have only done some upgrading of inexpensive RTRs so far.
I'm going to be getting the hull for the DF23 soon and need some advice.
I think I'm good on the external hardware installation and electronics but need help with the electronics internal mounting and hatch water sealing.
What is the best way to mount the motor and servo? Do I epoxy wood/plastic/alluminum mounting plates down or do I need to make stringer rails?
How do I make it water tight with the hatch?
The boats I have run have been app. 18 inch self righting boats with outrunner motors. Will a 23 inch boat with an outrunner be self righting? I'm gonna start with a 4000kv outrunner on 2s lipo.
will probably switch to 3200-3500 kv on 3s once I dial everything in. Any help would be appreciated.
I'm going to be getting the hull for the DF23 soon and need some advice.
I think I'm good on the external hardware installation and electronics but need help with the electronics internal mounting and hatch water sealing.
What is the best way to mount the motor and servo? Do I epoxy wood/plastic/alluminum mounting plates down or do I need to make stringer rails?
How do I make it water tight with the hatch?
The boats I have run have been app. 18 inch self righting boats with outrunner motors. Will a 23 inch boat with an outrunner be self righting? I'm gonna start with a 4000kv outrunner on 2s lipo.
will probably switch to 3200-3500 kv on 3s once I dial everything in. Any help would be appreciated.
Comment