Tweet
Had this "Old Wooden" 3.5 Tunnel sitting around for some time, and I've purged most of my other projects, so I figured I could tinker on this a bit over the coming months to hopefully make it useful again.
Not even sure what it is, but whoever built it did so with a LOT of skill and care. Pretty nice lines, well made, etc.
First step was to sand... and sand... and sand... sand some more... and I still have a little sanding to do.
Going to do some structural upgrades, and then update the layout to support an FE setup. Not for racing, just for fun. It's a TINY boat... 24", so I'm going to set it up for a high-revving 2S setup, which will allow the use of appropriately smaller props and will also keep it light.
Small_OPC_001.jpg Small_OPC_003.jpg Small_OPC_004.jpg Small_OPC_007.jpg Small_OPC_012.jpg
Not even sure what it is, but whoever built it did so with a LOT of skill and care. Pretty nice lines, well made, etc.
First step was to sand... and sand... and sand... sand some more... and I still have a little sanding to do.
Going to do some structural upgrades, and then update the layout to support an FE setup. Not for racing, just for fun. It's a TINY boat... 24", so I'm going to set it up for a high-revving 2S setup, which will allow the use of appropriately smaller props and will also keep it light.
Small_OPC_001.jpg Small_OPC_003.jpg Small_OPC_004.jpg Small_OPC_007.jpg Small_OPC_012.jpg
Comment