Tweet
Got the cf plates cut today that cover the hull cut outs. 20181101_112347.jpg
-
-
Got the rest of the parts I was waiting for and finally had a couple of days to finish her up. I did the stuffing tube and brace, transom hardware, servo mount, motor mount, esc plate, battery trays, cut my flex shaft, ran all the electronics and water lines. Then I built and mounted the wing supports from cf. Then mounted all the electronics and motor and set up the boat for the first run to be safe. Then put all the decals on. All that's left is to wax this baby.
20181210_165202.jpg
20181211_203820.jpg
20181211_231016.jpg
20181211_231042.jpg
20181211_232331.jpgLast edited by Vin-m; 12-14-2018, 08:37 AM.Comment
-
Maiden runs coming soon!!!Comment
Comment