Tweet
Does anyone know the thread size of this shaft?
ProBoat Heavy Duty Flex Cable SW36, TC31.
ProBoat Heavy Duty Flex Cable SW36, TC31.
-
-
This is it on OSE:
https://www.offshoreelectrics.com/pr...rod=hh-prb2052 -
This is the prop nut suggested.
https://www.offshoreelectrics.com/pr...d=mc-94205A230
Says "These work well as a propeller nut on 4mm threaded .7 pitch shafts"Have fun with that....
Comment
-
I was thinking about cutting the straight end of the one i have shorter and I would have to cut a new thread into it afterwards so i was hoping to know if the thread size was the same as the cutter i found which is 10 - 24Comment
-
I think it would be a 4mm die cutter. But you might not have to cut it, can you use a piece of fuel tubing between the nut and the prop to take up the extra room?
Sent from my iPad using TapatalkNamba District 16
1/8 Miss U.S., 1/8 59 Maverick, 1/8 Executone, 1/8 Smokin Joes, MLGSX380, AC Pro40II Q Sport, AC Pro40II nitro,Twincraft mono 10s, Vision AOPC, VS1 FE, M34.Comment
-
Hmmm. Thats an idea that never crossed my mind. Thank you very much for the suggestion I think I will do that instead of cutting my shaft.Comment
Comment