Mause Bullet Build

[SJFE]

Couple more pics.

[SJFE]

Update

I started with tabs tonight placment was tuff due to the turn fin bracket. The right tab is just a tick lower than the left. I'm not sure if thats gona be a problem. I don't for see one. Last I cut a Carbon Fiber plate for the servo & rx. Epoxied it in place to cure. Tomorrow night will I'll mount the servo rx and motor. I may get the water cooling run but I am in no hurry. It mat make the water this weekend.

[Doug Smock]

Sent ya a PM.

[SJFE]

Gotcha. Thanks Doug. I'll make the ajustment tomorrow. What do you think about the tab..more it or no?

[Doug Smock]

I don't think you need to, it doesn't look like it's off the mark much, hard to tell in the pic.
What are you going to power the beast with??:D

Doug

[SJFE]

Left tab in. Right fin out...LOL. I get it yet:D.

[SJFE]

7XL 120amp hex on 16cells...lol

[Doug Smock]

7XL 120amp hex on 16cells...lol

I can smell smoke allready!!
Your kidding right??:)

[SJFE]

12,14,16, 2s 4s. I'm not afraid of anything. If it will float with 16 i'll try it.:D

[Darin Jordan]

I think that is the perfect sized race hull for a 2S2P setup... Get a 6L or 7L from OSE and a B125 or bigger ESC and you'll be easily into the 45mph + range... NOT a sport setup, but a damn nice N2-Mono race setup...

[SJFE]

Thanks for the race setup:). I am how ever a sport boater for this season. So the Xl on 12 or 14 is more realistic for what I am going to be doing. I am hoping to get 40 out of it with out spening big money on an esc.

[hammertime]

i wish i had no fear like you lol

[SJFE]

It's more arrogance than bravery to be completely honest. See I am @ the point now where I know enough to be dangerous. I am lucky to have Mr Jordan & Mr Smock here for reality checks. After getting over the stupid and listning to reason I will be doing a 9 turn motor.

[SJFE]

99% Done

I started @ 8:00 tonight and just finished up for the eve. As you can see I got quite a bit done this evening. Thats possible when im not on here running my mouth(or fingers). All that is left are just a few odds and ends. I have some stickers to use for a bit untill I have some customs made up. I hope to get it in the water this weekend. I am going to have to be carfull. I only had a 7XL in inventory so that is what went in. I put on a 42mm prop for a jumping off point. I am dog tired so I'm out.
Peace.

[Darin Jordan]

Looks like a very well aligned motor mount!

Nice work!