Thoughts Needed Inside Please

[Tamelesstgr]

Gang,

I'm building raised engine covers for my V-hull. They were rounded and I didn't think they fit the lines of the hull really well. Trying to gauge scale, I think maybe shorten them so they aren't as high? They are .60" high right now

Thanks,
Ken

20160129_215725.jpg

20160129_215730.jpg

20160129_215734.jpg

20160129_215744.jpg

20160129_215752.jpg

[Tamelesstgr]

Look I'm gunning for:

01.jpg

7738.jpg

SP2301.jpg

[Yeeharacing]

Look I'm gunning for:

[ATTACH=CONFIG]140584[/ATTACH]

[ATTACH=CONFIG]140585[/ATTACH]

[ATTACH=CONFIG]140586[/ATTACH]

I did some freelance work for the current owner and restorer of Dry Martini. That boat has such a great story behind it. Plus the engineering that was put into rigging that boat and the original engines is mind blowing.
I started working for Kurt just after he found the original engines in a cave. He had just taken possession of them.

Your engine hatches look good I'd shorten them up just a little bit length wise so you get more of an angle on the front to match the hatches on martini. Height wise looks good.

[Tamelesstgr]

Awesome, thanks for the advice!