Trying to modify Servo Horn for Push Rod swivel

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • dmitry100
    Fast Electric Addict!
    • Mar 2015
    • 1264

    #1

    Trying to modify Servo Horn for Push Rod swivel

    Hey guys,

    So I'm trying to get this new aluminum servo horn going for my new low profile Savox instead of relying on my plastic one.

    But anyways, I ended up paying $10 bucks for this little guy and the swivel is too big in diameter so I had to drill a bigger hole for it.

    Swivel ended up being a tad bit short. What do you guys think I should do here so that the bolt screws into the swivel tightly and doesn't end up unscrewing during use?

    EDIT: Profiling it down worked just fine... just thought someone might of had a better solution.
    Attached Files
    Last edited by dmitry100; 08-04-2015, 08:48 PM.
Working...