Hpr 150

[hanspeter]

hello

here a small build process from my HPR 150. i will make the old good victory.
hull is bullet proof ultimate.

greetz hanspeter

[hanspeter]

Mounts from the waterp pickups drives rudder

[hanspeter]

drives an rudder

[ls1fst98]

Very nice!!

[Fella1340]

You never disappoint! Really looking forward to seeing what happens here. I'm curious about the drill and solid rod going into the drives, I had written a few guesses from lapping the bushings(if bushings are used), seating and running in bearnings and also it being a special tool for drilling into the hull for stuffing tube arrangement. None seemed to quite fit. What's going on there:-)!

[hanspeter]

You never disappoint! Really looking forward to seeing what happens here. I'm curious about the drill and solid rod going into the drives, I had written a few guesses from lapping the bushings(if bushings are used), seating and running in bearnings and also it being a special tool for drilling into the hull for stuffing tube arrangement. None seemed to quite fit. What's going on there:-)!

hi

this is a Special tool for Drilling the hole for the Flex and shaft tube. the drive is mountet in the optimal Position.
so i have the propshaft and the Flex 100% in the centrum

greetz hanspeter

[Fella1340]

Very good idea, takes any guess work out of things that's for sure. That's the type of stuff I love seeing in the high end builds. It really helps us newer builders become better. Thanks

[TheShaddix]

How does this tool work? Seems like a great idea to make that perfect angle from drive to stuffing tube entry point.

[flraptor07]

It's probably a long drill bit.

[TheShaddix]

maybe some kind of a tube that holds a drill bit? Hanspeter can shine a light on this mystery!

[Fella1340]

It would be a piece of precision ground shafting or tube the same size as the inside diameter of the bearings with a drill machined to fit the end. Nothing fancy but a really great idea. Every little bit helps getting things to run as true as possible.

[hanspeter]

hello

thank you. the next step is the mounting from the engines. i have make a Special
Support,and build this out from the boat. so i can make this 100% exact.

greetz hanspeter

[srislash]

hello

thank you. the next step is the mounting from the engines. i have make a Special
Support,and build this out from the boat. so i can make this 100% exact.

greetz hanspeter

Ahha, the flexible tubing for the stuffing tube. That is what I have been watching for. Where did you find that Hanspeter? I have been watching for old oil cans but that looks new. I have had thoughts of it for my HPR 115
Shawn