Tweet
Finally received my new stinger assembly from Hobbyking. My fault, I chose snail mail... Haha!
Here was my drive angle before.
ImageUploadedByTapatalk1342266683.447407.jpg
Here's the new one..
ImageUploadedByTapatalk1342266770.141804.jpgImageUploadedByTapatalk1342266795.856942.jpg
Note: waiting for new trim tabs, and added a new water pickup.. Prop is a "radioactive X55" (all the local HS had)
Tidied up internals too. Just waiting on the resin on the motor mount to set, then off to get it wet..
ImageUploadedByTapatalk1342267093.965372.jpg
As this is a nitro conversion, any ideas on how to fix the exhaust holes? I've just epoxied them at this stage..
Here was my drive angle before.
ImageUploadedByTapatalk1342266683.447407.jpg
Here's the new one..
ImageUploadedByTapatalk1342266770.141804.jpgImageUploadedByTapatalk1342266795.856942.jpg
Note: waiting for new trim tabs, and added a new water pickup.. Prop is a "radioactive X55" (all the local HS had)
Tidied up internals too. Just waiting on the resin on the motor mount to set, then off to get it wet..
ImageUploadedByTapatalk1342267093.965372.jpg
As this is a nitro conversion, any ideas on how to fix the exhaust holes? I've just epoxied them at this stage..