MHZ Mystic 1380mm build

[MrUnlimited]

Kent? 5800mph packs? Really?

[nata2run]

Kent? 5800mph packs? Really?

Yep super FAST LOL

sorry 5800mah hehe (hate those auto spell whatever)

[MrUnlimited]

Guys
Does someone know if there are templates to drill the holes in the transom for the trimax drives in the hull? My drives arrived today.

[Chrisg81983]

Mr unlimited do u have a build thread I would like to follow it. The build sounds very interesting

[Chrisg81983]

Oh and kent where can I get the 5800 MPH packs sounds awesome and sorry for the double post

[MrUnlimited]

www.v10power.ws is my blog

[MrUnlimited]

Kent, how did you measure the holes for the drives?

[nata2run]

Kent, how did you measure the holes for the drives?

...I used a template only made in paper printed on my printer
here is how http://forums.offshoreelectrics.com/...529#post420529

[MrUnlimited]

Guys,
What loctite do I use for glueing the flexshafts into the outdrive-axles: 603 or 638?

[nata2run]

I use 648, but I think the ones you mentioned will work as well

[MrUnlimited]

Thanks Kent, what is the length you have cut the flexshafts before glueïng?

[Alfa Spirit]

Well Mr Unlimited what is your complete setup for your Mystic 1380mm ?

[MrUnlimited]

I bought these week 730KV Protues motors, I'll expect them to arrive next week. They will be powered by 10s lipo each. As for the probs I'll contact Andy Brown to modify some 2 blade prop for me and for esc I 'll go for the new Fliermodel 300A esc which can be programmed like the hobbywing esc (I run a Xerun 60A in my Tamiya Avante2011).

[nata2run]

730kv on 10s? That would not be fast, unless they turn to 1360 in wye mode?

[nata2run]

Thanks Kent, what is the length you have cut the flexshafts before glueïng?

Didn't make any cuts before gluing. I just glued them in, and then cut to size after I measured the distance. I used a flex cable to measure. Feed it up till it hits the motor shaft, then apply some tape on the prop end and use that as a guide.