Tweet
I got this in a trade from a member here and decieded to build if i got a little of the way installing mat with fg resin that i mixed weak to not warp the abs hull but ill try to have regular post from now on i also fabbed a mount and installed some rails at 4"
-
-
flex
http://www.hobbyking.com/hobbyking/s...ible_axle.html
shaft
http://www.hobbyking.com/hobbyking/s...th_thread.html
drive dog
http://www.hobbyking.com/hobbyking/s...dproduct=12713
stinger
http://www.hobbyking.com/hobbyking/s...e_Silver_.html
trim tabs
http://www.hobbyking.com/hobbyking/s...Trim_tabs.html -
havent chosen a rudder or turnfins yet but this is what i was thinkingComment
-
Thanks, alot of good info there, I will be laying some fg cloth in soon and start collecting hardware ect, and decide what size motor to put in it on 3-4s with about a 60 amp esc.Comment
-
Installed trim tabs stuffing tube and support for stuffing tubeComment
-
looking good i hope your glass will hold better than mine did it did not stick to the abs very well, probably my fault though, i used ca and 2 layers of glass on my OM29 also stringers thing was hard as a rock. i am interested to see it with the ul-1 power i think it would be a force in a P-limited mono classComment
-
got it painted will join tomm and double clear coatComment
-
Paint looks good dude! you are almost there. we are starting to develop P LSO class here, so when you make it down, you will have some competition.
nice job!"Look good doin' it"
See the fleetComment
-
thanks Jesse we have to catch up ive been super busy and have a vacation coming up for the 4th of july but after that ill have to go up to KatyComment
-
hurry up already, boat looking good how did u spray the boatComment
-
i tried this out because it said it bond to plastic, but i will also clearcoat it with a clear laquer
Comment
Comment