Aeromarine Titan 40 build and sprintcat 90 with twin cc1717

[Chrisg81983]

i just started two builds one a titan 40 and the other is a sprintcat 90 with twin cc 1717
sprint 90.jpgtitan1.jpgsprint 90 pic2.jpgsprint & titan.jpg

[Chrisg81983]

i got the trim tabs mounted up on the titan today and i am waiting for the rest of my parts from ose they should be here tomorrow or the next day i have everything for the sprintcat except lipos thanks to dasboata. i should be starting that build any day now.

titan tabs 2.jpgtitan tabs.jpg

[Chrisg81983]

i was just wondering if anyone had some imput on where i should mount the motor (leopard 4082 - 1550kv) front or rear mounted.

[jkr]

Hello.
What set up you will use for the aeromarine?

[Make-a-Wake]

i was just wondering if anyone had some imput on where i should mount the motor (leopard 4082 - 1550kv) front or rear mounted.

I personally like the motor up front more........................somewhere in the 30-35% from transom range...........batts aside and front and back movement is possible then.

[Chrisg81983]

Jkr- They are both aeromarine one a Titan and one a sprint cat 90 I am using a leopard 4082 1550 kv with s seaking 180 with extra cap bank on the Titan
On the sprint cat I am running twin cc 1717 with two seaking 180's with extra cap banks
Both builds are done with all speed master hardware and will be runningon 6s

[Chrisg81983]

Make a wake-That is what I was thinking as well thanks for your imput

[jkr]

Jkr- They are both aeromarine one a Titan and one a sprint cat 90 I am using a leopard 4082 1550 kv with s seaking 180 with extra cap bank on the Titan
On the sprint cat I am running twin cc 1717 with two seaking 180's with extra cap bank
Both builds are done with all speed master hardware and will be runningon 6s

Thank you.
I was asking for the titan.
I recently bought a 40'' hull OHIO STEEL (Dragon Lady from mhz i supose) and was thinking for the 1600kv leopard on 5-6s 2p

http://forums.offshoreelectrics.com/...-Ohio-steel-40

[Chrisg81983]

Thank you.
I was asking for the titan.
I recently bought a 40'' hull OHIO STEEL (Dragon Lady from mhz i supose) and was thinking for the 1600kv leopard on 5-6s 2p

http://forums.offshoreelectrics.com/...-Ohio-steel-40

very nice i wish you luck i will keep a eye on progress

[Chrisg81983]

i am almost finished with the titan build i have all hardware mounted battery trays motor mount and servo mount mounted i just half to run the cooling lines
inside.jpgmotor installed.jpgservo mount.jpgfins.jpg

[Chrisg81983]

hopefully i should get it in the water tomorrow then i am starting the twin sprintcat build

[Make-a-Wake]

Went with rearward mounted motor i see.......................your batts can easily adjust your cg as needed with all that fore/aft room.

[Chrisg81983]

yeah i did because i felt i could get a better layout to better adjust cg and have a shorter drive cable plus i never had a rear mounted setup i figured i would try it out and see how i like it

[Chrisg81983]

I got to ran the Titan today it went real well boat was fast and real stable I just half to dial it in a little more and then start to play with some different props I will have some videos up tomorrow

[dasboata]

Looking good Chris !!!