F1 Skater Tunnel Hull Build

[SANTAVY1]

Started my F1 tunnel hull build today. New at tunnel hulls so I will have a lot of questions on this one. Heres what I have in mind.
25.5" H&M F1 Skater hull
Pro Boat outboard unit for the scale look(I think it will look killer on this hull)
UL-1 2030kv 6-pole motor
Not sure on ESC but looking at Swordfish 120 amp or Seaking 90 amp(open to suggestions)
Prop=start out with a grim 42-55 and see how that goes?????

Haven't see to many build threads on the skater hull, any thoughts on this hull?

Here are a few pics with the graphics I put on today.

[JCAustralia]

Woah great

I am doing a similar build and using a K&B leg.

Will be watching this thread

Good luck.

[photohoward1]

Looking Good!

[SANTAVY1]

Built a removable waterproof ESC/Battery box. Installed the push/pull cables and got my Pro Boat outboard motor mounted up, looks awesome Set the bottom of the bullet about level with the bottom of the sponsons. I left room for adjustment up or down cause I'm not quite sure where it needs to be on this hull?
The outboard sat to close to the transom so I had to make a standoff bracket for the motor this would allow good clearance for the steering arm.

[SANTAVY1]

few more picts

[HOTWATER]

That motor looks really good on that tunnel! I really like how the profile of the cowl matches the motor cover's profile angle....

Good build...looks like you have done your homework on it...

-Kent