First boat, Delta Force 35" Pirate

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • chummer
    Senior Member
    • Mar 2009
    • 636

    #241
    Originally posted by millzee
    I just made a shorter video of the last run only, the long video was too annoying even for me.
    http://www.youtube.com/watch?v=U_hjJX8lqZM
    What prop?
    "IT IS BETTER TO REMAIN SILENT AND THOUGHT A FOOL THAN TO OPEN YOUR MOUTH AND REMOVE ALL DOUBT"

    Comment

    • millzee
      Ozzie Bloke
      • Nov 2010
      • 1092

      #242
      Originally posted by chummer
      What prop?
      I'm finding the x450 to work well.
      http://www.youtube.com/user/1millzee?feature=mhum
      "Gimmy Toyz for FUN"

      Comment

      • millzee
        Ozzie Bloke
        • Nov 2010
        • 1092

        #243
        I got a couple of runs in tonight and managed to get 91.6kph out of it, not much of an improvement but I was only playing around with battery placement. I will still have to tickle the strut and reintroduce the trim tabs. I put on some larger turn fins from ose and they rock, no more hopping in the corners at 1/2 -3/4 throttle, I'm very happy with them although due to my getting to like high speed turns and having a fare crowd, I managed to spin out several times, a few times I had big flips, the first 3 or 4 time I got lucky and landed upright, it was the high speed run, a bit unstable into unsettled water that caught the nose and sent the boat into 2 or 3 end to end flips that landed her upside down. I kayaked out and turned it back over within 5-7 minutes and a friend drove it back in whilst I paddled back. Very happy, not a drop of water in the hull, so I checked temps and through it back out until the LVC kicked in. Temps where all good, probably 5-6 minute runs and the motor only got to around 42c-107f, the esc was about the same but the caps around 63c-145f after the lvc kicked in. Batteries stayed around 40c. I'm sorry I didn't get any video as I would have finally had some entertaining footage but I just didn't have enough time to organize it, this was a spur of the moment run between busy spells.
        http://www.youtube.com/user/1millzee?feature=mhum
        "Gimmy Toyz for FUN"

        Comment

        • millzee
          Ozzie Bloke
          • Nov 2010
          • 1092

          #244
          Here's some video of today's efforts, short and sweet, top speed of 96.9kph - 60.21mph, I'm getting close to my goal of 100kph
          http://www.youtube.com/user/1millzee?feature=mhum
          "Gimmy Toyz for FUN"

          Comment

          • Make-a-Wake
            FE Rules!
            • Nov 2009
            • 5557

            #245
            Much different boat than when you started the thread..................I think you're there
            NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE: http://forums.offshoreelectrics.com/...est!&highlight=

            Comment

            • gerardobrandao
              Senior Member
              • Mar 2008
              • 164

              #246
              DF 35 Hull Mono

              Hello guys...


              Just to give an idea of mine DF 35 hull....
              It´s running good, but i need to trim it a little bit...but i can assure it that´s an animal on the water...most of time i can´t WOT....Hope you like it , and it seems of comparising to your setups...runing 65-68mph

              Running almost 5 minutes and batteries at the end all about 3.55V but WARM...




              Best Regards

              Comment

              • millzee
                Ozzie Bloke
                • Nov 2010
                • 1092

                #247
                nice, I think I'll have to re think my goal. well done
                http://www.youtube.com/user/1millzee?feature=mhum
                "Gimmy Toyz for FUN"

                Comment

                • millzee
                  Ozzie Bloke
                  • Nov 2010
                  • 1092

                  #248
                  would a x548 get things a little hot do you think?
                  http://www.youtube.com/user/1millzee?feature=mhum
                  "Gimmy Toyz for FUN"

                  Comment

                  • gerardobrandao
                    Senior Member
                    • Mar 2008
                    • 164

                    #249
                    X548

                    Originally posted by millzee
                    would a x548 get things a little hot do you think?
                    Hello Milzee


                    The best think i can tell you is give it a try for 30 seconds...and check temperatures...!
                    Mine NEU was pushing easily the the X648, about the Castle 1717 can´t tell anything..

                    Try it..

                    Best Regards

                    Comment

                    • millzee
                      Ozzie Bloke
                      • Nov 2010
                      • 1092

                      #250
                      sorry to post about this boat again, just trying to tie it all up.
                      This boat no longer exist, it's now here http://forums.offshoreelectrics.com/...ild&highlight=
                      http://www.youtube.com/user/1millzee?feature=mhum
                      "Gimmy Toyz for FUN"

                      Comment

                      Working...