Tweet
Hey peells,,, it was running loose and yes it has cooling. I ran it for a few laps not constant WOT,, if i put the 427 on the motor runs around 115, esc cool and bat cool... It has a velienon motor 3500kv 380 size i think and the turnigy marine 35 and 3s 1500mah lipo.. I took a vid and hope to get on here soon..
-
-
Heres the vid!!!!
let me no what you think,, i have some 2s 1500 batts i can use if you think i need to go with a smaller batt,,
Comment
-
Looks fast Jerry! I'd bet that a lot of the heat buildup was because of the partial throttle running. How deep is the strut? You could detongue the x430 to free it up a bit also.Comment
-
Thanks Rum, the strut is even with the bottom edge of the ride pads,,as for detongueing the prop i dont no how and (I) wouldnt want to screwup the prop maybe i can send it to Iceman and get him to do it for me and S/B some of my other props at the same time.. Yeah i need to run it WOT to help keep it cool.Comment
-
I forgot this prob i have,, if i run it calmly its dry inside but if i run it WOT alot it gets water inside,, any ideas i put a peice of heatshrink on the stuffing shaft where it goes in the strut hopping this cures it..Comment
-
You may be getting driveline vibration. Does it vibrate bad if you give it a quick bench test?Comment
-
i dont think so, i thought i had it pritty straight but ill power it up tonight and check it,,do you think i need to wind it up or just give it alittle throttle like half way or something??Comment
Comment