Twin Mean Machine Project Need some suggestions

[Jacked1]

Yea that is what i was thinking!
I would be very happy if my final speed was 70ish. That would show those gassers i know business! (btw i went and visited a club about an hour away with all gassers and they all acted like I was dumb and had some niko and radio shack boats when i said i had some electric boats, so i need to make them all feel pretty bad.)

[Jacked1]

Got the outdrives!

[RandyatBBY]

The problem I found with high pitch is amp draw. I tried to pull 5 inches with a Little Screamer on 102P and blew my 40.160. It was a 640Kv motor. It may work ok with 2.6 to 3 inches of pitch on 200 amp esc.

[Jacked1]

Yea that is a 90mph prop speed with a bigger prop and only one of them so i can see why! That is 24000 rpm on a big gasser prop when you would be lucky to get 16000 unloded on a gas motor or maybie 18000-19500 rpm on bh hanson with 7+hp.

The 51s would be a 82 mph prop speed and a smaller boat. I don't think i will be able to run it wide open for more than a few seconds anyway. lol

I have a big gasser hull that i am almost done with putting two 880 kv versons of this motor in if you are interested!
http://forums.offshoreelectrics.com/...ad.php?t=16689

[Jacked1]

Finally worked on this one some more. went with these motors.

http://fightercatracing.com/index.php?page=shop.product_details&flypage=flypage.tpl&product_id=32&category_id=11&option=com_virtuemart&Itemid=1&vmcchk=1&Itemid=1

And I am going to put them on 6s with the cheepo 200amp esc's.