Are you going to continue this thread on thro to the launch? Your thread is definately an education to me. my kit is supposed to be shipped this monday. I am anxious. Again your boat is very impressive.
Whiplash / UL-1 Hatch and Canopy
Collapse
X
-
-
Here's more pictures. The White Urethane is easy to repair. I have a few spots (dust in paint and overspray) that need it. I will sand bad spots out using 1500 grit paper then polish.Last edited by detox; 08-15-2010, 07:56 PM.Comment
-
Today I ran my Whiplash for the first time. Water conditions were slightly wind choppy (4 inches), but Whiplash handled the rough conditions much better than my UL-1 would have. Using the Octura M445 speeds were slighty above 50 mph. Very Impressive using just the UL-1 motor /esc combo.
I installed slightly too much lead in the sponson tips. Hull would not get on plane without throwing hull out onto water. So I moved my lipos more reward toward motor and now hull will jump on plane from a standing still start. Hull weighs 5 lbs 13 ozs using the LSH setup.
Hatch is a breeze to tape.
Rudder works verywell installed on the right side of stern as Speedmaster intended it to be.
The UL-1 boat stand works with the Whiplash also.
Virginia Craftsman turnfin works well as far as I can tell.
...Last edited by detox; 08-21-2010, 01:14 PM.Comment
-
Excellent job and thanks for posting your nice build thread. Looks great in white !
I went for orange, needs some decals...Attached FilesNortavlag Bulc
Comment
-
Nice,excellent job buddy,iv been watching this from the start and must say youve done a brill job of this build and fast aswell
Rgds F1http://s577.photobucket.com/albums/s...79/F1%20boats/
Daz from sunny EnglandComment
-
Thanks. My wife always did say that I sounded like a Georgia Hick when I talked...now I know.
Next I will try a couple more props (H1518-10-75 (3), H10) to get the fastest speeds, then I will take a better video of my Whiplash running around pond.Comment
-
Just purchased one of the new Nano Tech lipos. The pack measures 155mm long x 48mm wide x 35mm tall.Attached FilesComment
-
Good job on the boat and hatch. Thanks for sharing!Steven Vaccaro
Where Racing on a Budget is a Reality!Comment
-
Comment
Comment