Have hulls and hardware etc.....just don't know

[boater76]

I have hulls, hardware and etc. but I just don't know where to begin. I am overwhelming myself. I have a 26" v hull, Kyosho Wavemaster, hardware for small hull, 2s and 3s Lipo packs, 3600kv Turnigy watercooled, Octura strudder setup with .098 flex. Point being just don't know where to begin or what to build up or get first etc. Anybody want to put thier 2 cents in? Thanks guys!

Ken

[winner]

just take all the best stuff and through it in a nice hull and enjoy =]

[crabstick]

http://www.offshoreelectrics.com/info.php

Start here.. should have all the basic info you need.

That motor is going to be a 3s motor Max, being that high in KV.

you are going to need some reasonably high discharge lipos to feed it, and a reasonable ESC. What are the MAH and C rating of your existing lipos

got pics of this 26 inch V hull ?

[domwilson]

Post some pics of what you got and we can start from there.

[Jesse J]

agreed, spread it all out and take photos. provide specs and I am sure you will end up with a fun ride.

[boater76]

I'll get measurements and pics of hulls tonight or tomorrow. As for hardware it's for micro/mini hulls. I have a Turnigy 3600kv built in watercooled jacket motor and a high mah 2s and 3s lipo packs.

[Rumdog]

is it a 540 size motor? (36mm) S,L, or XL length can?

[boater76]

Shaft 4mm, diameter 35mm, can length 34, total 73mm

Ken

[boater76]

http://hobbycity.com/hobbycity/store...r_(WaterCooled)

[boater76]

Here is the Wavemaster 24" long by 10 3/8" wide.

[boater76]

Here is the V Hull, 24" long by 9 1/4" wide.

[6S HYDRO]

Do the wave master all the way

[Rumdog]

That motor will be too small for either application though.

[boater76]

I am getting a small hydro hull from someone on here. I will keep the v hull and possibly sell the outboard for the Wavemaster depending on whether or not I think it could handle a brushless setup.

Ken