Apparition on 6s with typhoon 1800kv

[Graeme]

Well took the Apparition out tonight with Turnigy typhoon 1800kv and six cell Lipo.
I managed to get 52mph before the gps died on me.
I did 4 WOT runs before bringing it in to check temps esc was 86 motor was 130.
I tryed to get a video but the camera man didn't know how to work the camera.
next time I will be sure to get a video and fully charged gps batteries.


This motor is Awesome even on 4s its much faster than stock and stays cold 80 deg.
Also it has way more torque and I would guess I get an extra 5+ minutes of run time.


I was thinking of putting this motor in the red evo but now I am reconsidering as I think it would be a little much.

IMG_2584.JPG

IMG_2587.JPG

[Graeme]

forgot to mention prop used 40mm X 1.4.
I think I will try larger on 4s as the esc and motor were ran cool.

[Jeff Wohlt]

So you mention 6S in the header....will you be trying that?

[Graeme]

I did try it on 6s I see the confusion I was not too clear in my explanation I will change it
thanks.

[FighterCat57]

Cool! The outrunners seem to be the way to go!

[Graeme]

Yeah I can't believe the torque difference and the sound they just sound mean.

I will try to post a video soon.

I think I am going to try one in the genesis cat when I get it.

Cool! The outrunners seem to be the way to go!

[Make-a-Wake]

I wonder if a 38mm prop would bring the temps down just a tad on the motor, and maybe even let it rev out a bit more...........may end up being as fast but cooler............????

[Graeme]

on 4s it runs a sold 43mph and cool i think it will be a good reliable set up of 4s
my gps is too heavy and causes a bad list so it's probably more like 45

I definably need a smaller prop for running on 6s motor temp was 150 esc was 80.
and something was smoking I am hoping it was just the 4mm bullet connects. I have larger ones on the way.
anyway here is a video on 6s it flys
IMG_2596.JPG

[Graeme]

the other thing I changed was timing from 11.25 deg to 15deg
not sure if that had an impact on the motor heat or not

[ray schrauwen]

Yes, it should be at 15 degrees.

[Graeme]

I wonder if I can break 60 with this set up will have to try a smaller prop and a smaller GPS.

[britscoot]

I'm going to put that typhoon motor in my red evo!
will try it on 4s and work my way up!
Small prop also.

Wish me luck....hahaha

[FighterCat57]

I wonder if I can break 60 with this set up will have to try a smaller prop and a smaller GPS.

I'm not so sure. More like 55 I think.
Running T180 CC/Neu 2650Kv on 4s w/440 was 58mph (39k RPM) and had to go up to 8mm motor bullets. I melted the solder connections on the Castle 6.5mm bullets. Probably could have gotten 60 w/442 but kept breaking the drives... Too much RPM.

Depending on your lipo weight and I think the Typhoon is lighter... might get close to 60.

[Graeme]

I think that with a small gps I could probably get there the one i am using weighs more than one of my lipo packs.
where does one buy a cheap light gps from ?

I am loving this set up I bought the typhoon for the surge flusher and never installed it before I sold it.

[FighterCat57]

I think that with a small gps I could probably get there the one i am using weighs more than one of my lipo packs.
where does one buy a cheap light gps from ?

I am loving this set up I bought the typhoon for the surge flusher and never installed it before I sold it.

Look for a Forerunner 101-301 or Foretrex. Nice, small and simple. That's what I use. I'm still trying to get my Apparition to break 60 reliably...