Yep, should be stellar.
Noisy person
For you Plettenberg owners with the 12mm shaft coupling system- did you have to tap the two small holes to thread for set screws? The holes are smooth bore from factory, at least mine are.
IMG_1965.jpg IMG_1966.jpg
Agreed with Chris, those holes are likely to engage the setscrew cup points on the coupler.
Don't those motors come with some type of coupler?
Tyler Garrard
NAMBA 639/IMPBA 20525
T-Hydro @ 142.94mph former WR
You are missing the most important part! See the photoimage.jpg
The TERAS is only a 4 pole motor so choose high voltage/power esc.
If it was a 12 pole or more that' s different.
Definitely missing the outer ring. The inside is good to go for. ?? shaft. I have 2 of these. If you want to run a 3/16? shaft use a piece of ? material and an Octura ? to 3/16 coupler.
Sent from my iPhone using Tapatalk
Hey jevmax, do you do anything to your cable so that the set screws grip? I tried sanding a flat spot on the cable for the set screws to grip, but the motor tore up the cable in less than a minute. I tried silver braising the shaft then sanding a flat spot for the set screws, but again the motor tore up the cable.
Thanks for any suggestions!
If you can solder the last inch of the cable that will help it hold together. Even with that, after repeated uses the set screws do chew up the end of the cable. Not need to put a flat on the flex cable. The set screws will hold.
Thanks jevmax!
Bookmarks