I have an R model Genesis with the two 4082 SSS motors - is there anyone who might know the Kv of these motors? The paperwork that comes with these boats is worthless.
Thank you in advance.
I have an R model Genesis with the two 4082 SSS motors - is there anyone who might know the Kv of these motors? The paperwork that comes with these boats is worthless.
Thank you in advance.
i can be a 2200kv,tfl sells them as an upgrade
you can run the motors on 6s but check temps and for props 43mm is max prop dia (a set of ABC 1715-17 give a lot of speed) it take some time and testing to find the sweet spot
Thanks again Koen. Locating a set of those ABC props will not be easy but I will give it a shot. I do have a set of ABC 1815 -17 so I could try those while checking the heat. Maybe try them with
5S first and then sixes if I can get them in and out of the boat. Those are a tight fit.
Is this your boat? https://tflnorthamerica.com/product/...fshore-rudder/
If so you are looking at 2075kv. I can’t find the spec sheet but I would say yes to 6s as a SAW build if you could make it fit. Now prop size will be important also those seaking 180s will get hot if you are not careful. They recommend 2 4s packs but I think that is because of fitment not the motors or esc limits. The Zonda runs on 6s with the same setup, actually I think the Zonda comes like 2200kv. Again 6s would be a drag style setup not for sporting around.
Player thanks for the reply. I believe what i have is the Zonda with the blue and gray paint scheme. I think i will stick with four or five S in it as that is fast enough. I have a few other boats for speed that I can slip those six S batts into. Again thank you.
ALfa - Thank you for your reply. I do believe what I have is the Zonda with all the trimmings. In any case I will stick with four or five S as I mentioned in my reply to Player and use the other boats for six S.
Bookmarks