UL-19 Proboat headache #69

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Zondar
    Member
    • May 2015
    • 58

    #1

    UL-19 Proboat headache #69

    Help! Experts!


    Think I toasted my Proboat DYMN 3831 (stock) 2000kv.
    5000mah, 3s series, RCBB 175 ESC. All mods previously installed (fin,2 port water delivery, ESC CF rails). Not sure of 3 blade.( smaller than stock)
    Cooling can and collet welded to motor.
    Will heat loosen up so I can dyno motor for damage?

    Thanks for your interest,
    Zondar




    UL-19, Spartan, TFL CF River cat, RC Marine MTR, Proboat Impulse, Bonzi FE Skater
    Traxxas Spartan, RCBB Zonda-R, Promarine MTR, Proboat IMP 31 v3, PB UL-19, Bonzai FE 47 Skater
  • Jesse J
    scale FE racer
    • Aug 2008
    • 7116

    #2
    “ Will heat loosen up so I can dyno motor for damage?”

    What does this mean?
    "Look good doin' it"
    See the fleet

    Comment

    • fweasel
      master of some
      • Jul 2016
      • 4282

      #3
      If you overheated the motor enough to cause issues removing the water jacket AND collet, it's junk. Even if the thing still spins, the magnets surely have been demagnetized enough to have lost a significant amount of power. Time for a replacement, and then figure out why you toasted this one so you don't do it again.
      Vac-U-Tug Jr (13mph)

      Comment

      • koen
        Senior Member
        • Mar 2020
        • 358

        #4
        Ironclad rc on youtube has a lot of info for the UL-19

        Comment

        • Zondar
          Member
          • May 2015
          • 58

          #5
          Thanks, gents, for your valuable response. Appreciate!



          Zondar
          Traxxas Spartan, RCBB Zonda-R, Promarine MTR, Proboat IMP 31 v3, PB UL-19, Bonzai FE 47 Skater

          Comment

          Working...