Aaron,
Do you tried calling Charlie at (256)-384-6946?
The tool to aligning the strut is a simple 1/4" strip that just helps center the strut and rudder bracket vertically on the transom. I would recommend using the pushrod hole to position the rudder bracket and then use a straight edge on the top of bottom surface to align the strut at the same level.
The inside transom fiberglass piece is a glued on the inside of the transom to keep the nuts from deforming the wood when tightened. It's a big backing washer.
Tyler Garrard
NAMBA 639/IMPBA 20525
T-Hydro @ 142.94mph former WR
Bookmarks