Ok so i got a new setup for my proboat 36 since i burned down the esc....And now i am running a leopard 4074 1800kv with 150a esc and hoffman?s sonic 2 prop...had posted other issues and different threads where i had collet heat issues were it was slipping The flex shaft and causing heat fast in the collet which there for spread to the motor making even more heat....Mind you i have since i had this boat have also adjustable trim tabs, dual rudder pick up, bigger cooling lines ,ose upgraded flex shaft , new collet,and its a d wind motor timed at 0 degrees ...And yet i still have so much heat were it started smoking a little and this is only with 2 passes mind you...And yes i had put the stock prop on and still have issues which makes no sense since it is well better of then it was in stock form....I am getting to the point were i thing this motor is binding or bad bearings out the box...Everything is super cool to the touch shaft,esc,collet,lipos,except this dam motor which I purchased here from OSE so yeah that were im pretty much at so any suggestions im all ears but man process of elimination at this point ...
Bookmarks