Finally able to try things out with the weather and all (snow showers expected on Thursday here, Yea)
Anyways, my crue will is not going as expected,
seaking esc 120amp V2
AQ 3650 2030kv
5mm connectors (both esc side and motor side)
Grim Racer 42/55 prop b/s
OSE upgraded flex shaft
1/4" space between dog and strut
strut about 1/8" above and flat to start.
c/g is about 10inches from transom,
Started with 2s4p would not get get up on plane (voltage on all cells 4.2)
Tried 3s6p still would not get up on plane (voltage on all cells 4.2)
Re-position batteries (both sets) front to back for c/g and tried (still no go on both)
Double checked throttle position (Sprectum dex4c tx and sr310rc) seamed A/OK (but not sure) Just doesn't seem like it should be getting the rpm's (on the desk) that it should be getting
Bearings seems to be good, although turning by hand its seams tight (thought that may be because of being 6 pole)
I'm lost,
Could the motor just have gone be bad? ran great last year
John
Bookmarks