okay hoping you guys can help me out. a while back I burned up my factory ESC on my old proboat Formula Fastech and scored a deal on a Turnigy Aquastar 90A and programmer to replace it with. but I can't seem to get this thing sorted out. I hooked up the programmer and just set it to default settings hit enter and unplugged it from the programmer and back into the receiver. from there there I've tried every wire combination to the motor and get nothing. lots of random beeps depending on the wire combo and at one point the prop spun (completely by itself without any controller input) and nothing since. any ideas? not sure what else I can try. nothing came with any kind of instructions and I'm not sure what else to try. running twin 2 cell 7.4v 5000mah lipo's. tested the receiver and it's functioning fine.
obviously given the motor randomly spun the one time I'm guessing it's all good. anybody have one of these programmers is there something I'm doing wrong to program? thanks.
IMG_20200419_105819.jpgIMG_20200419_105815.jpg