Need help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Vin-m
    Senior Member
    • May 2014
    • 308

    #1

    Need help

    I'm running a hydro w a etti hv esc and a neu 1527 1.5y motor octura 450 prop on 10 cell and the boat revs out w no load but when I put it in the water for the first time today it can't Rev up.... If I hold the prop out of the water then pull full throttle and hold it, then drop the boat into the water it'll take off like a rocket and hold speed until I let off the throttle. Once that happens it can't Rev out again when the throttle is pulled again. I have tried changing the low voltage cut off from the 10 cell setting to disabled. I have tried changing the timing of the motor. I have tried changing the pwm settings. On the telemetry there is no large voltage spikes. Nothing seems to work. The batteries are brand new. Any ideas fellas?
  • jingalls007
    Fast Electric Addict!
    • Mar 2009
    • 1015

    #2
    What boat is this? Is there space between your drive-dog and the strut? Etti 220 HV? Is your collet tight?

    Comment

    • Vin-m
      Senior Member
      • May 2014
      • 308

      #3
      It's a hydro and marine hull. There us space between the drive dog and strut. Collet is tight. And it is an etti 220hv.

      Comment

      • jingalls007
        Fast Electric Addict!
        • Mar 2009
        • 1015

        #4
        Did you set the throttle endpoints on the ESC? Which H&M Hydro?

        Comment

        Working...