Rear support mount for 40mm motor

[fweasel]

Been working on my Voracity on and off this winter prepping it for a new motor and ESC. Today I drew up a template and cut out a rear motor support from 3mm carbon plate. In order to match the angle of the existing stuffing tube, I needed a slight bend past 90* in the stock motor mount, and a support at the rear of the motor can to make up the gap. I should be able to use the stock rear clamp with some longer M3 screws once this is epoxied in place. The new motor is a TP4060 with a full length water jacket.

IMG_20191228_181829.jpg IMG_20191228_181748.jpg IMG_20191228_181730.jpg