Originally Posted by
stac1627
Hey Fluid,
I solved the issue...
I'm running twin motors with twin Raider 150 esc's each powered by two separate Nimh packs...14.2 volts at 4500mah each. The packs were sitting a while and the esc's were programmed with a low voltage cut off. I charged up the packs and programmed the esc's to not have a low voltage cutoff. All works well however I have another issue and I can't figure out what I did to cause it. Forward works on both motors perfectly but I get no reverse from the right engine...just left.
Check the programming on the esc's. It is likely that one is programmed for/rev and the other forward only.
NZMPBA 2013, 2016 Open Electric Champion. NZMPBA 2016 P Offshore Champion.
2016 SUHA Q Sport Hydro Hi Points Champion.
BOPMPBC Open Mono, Open Electric Champion.
Bookmarks