Anyone know the size bearings used in the TP Power 4050 V1 (gold end bell) motor? The OSE store lists sizes for the older V2 and I'm not sure if they've changed.
Anyone know the size bearings used in the TP Power 4050 V1 (gold end bell) motor? The OSE store lists sizes for the older V2 and I'm not sure if they've changed.
Vac-U-Tug Jr (13mph)
I am not sure of the gold end bell ones Ryan, but my V2’s (4050&4030) wer 5x11x5 with the mount end being flanged
I haven't had the time to pull the motor and pop the bearings to measure myself. I'll get around to it eventually and will post the measurements here.
Vac-U-Tug Jr (13mph)
8 x16 x5. All the 5mm output shaft are machined down from 8mm on the ones I have. I just replaced a set in one motor last week.
NZMPBA 2013, 2016 Open Electric Champion. NZMPBA 2016 P Offshore Champion.
2016 SUHA Q Sport Hydro Hi Points Champion.
BOPMPBC Open Mono, Open Electric Champion.
Turns out my bearings weren't bad. First run after the Boca swap, still had the squeal. It was caused by a cooling hose stuffing tub seal that was a bit too tight. Oh well, spare bearings are never a bad thing.
2019-09-19 19.46.26 (Medium).jpg 2019-09-19 19.46.42 (Medium).jpg 2019-09-19 19.47.32 (Medium).jpg
Vac-U-Tug Jr (13mph)
Bookmarks