Darin Jordan ask me to post this. Its Grims instruction manual for the AquaCraft UL-1 water jackets. Download the file for both text and pictures.
Installation of the UL-1 water jacket
Parts and simple tools include:
Block of wood, popsicle stick and oil.
Drill a 13/64” (but any size large enough for the shaft will work) hole in a block of wood.. (old 123 blocks work good here too)
Slip the motor shaft into the hole and stand the motor on end.
Place oil near o ring
Coat o ring with oil
Slide one of the outer rings in place
Slide the lubricated O ring in place
Using your fingernails and or popsicle stick push the O ring in to place (Hint: This works best if you cross install the O ring (left, right, top, bottom, 45deg, opposing 45.. you get the picture.. also if using a popsicle stick rolling the stick works better then just pushing).
Slip the center barrel in place and using pressure screw the barrel in place. DO NOT OVER TIGHTEN!!!!!!!!!!!!!!!!!!!!!!!!
Repeat lubrication of second O ring.
Slip the O ring over the motor
Install the second outer ring
Push the outer ring straight down then with a slight wiggle as needed to set the O ring.
Thread the outer ring in place. DO NOT OVER TIGHTEN!!!!!!!!!!!!!!!!!!!!!!!!
Bookmarks