New to boats, have a cheaper China abs boat I've been upgrading and completely redid everything from original setup. It's a 800mm with a 150 amp flycolor esc, turningy1650kv 70amp 2600 watt, 3674 motor running a 3/16 flex driven drive setup on 6s. What's a good prop size to start with?
Prop size?
Collapse
X
-
You should start smaller, 40-42 mm and test and check and work your way up in prop size.NZMPBA 2013, 2016 Open Electric Champion. NZMPBA 2016 P Offshore Champion.
2016 SUHA Q Sport Hydro Hi Points Champion.
BOPMPBC Open Mono, Open Electric Champion.Comment
-
Cat or mono? Racing or sport running? Exactly what batteries? What is the length of the pond?
An x440 would probably be quite safe as long as the boat is properly trimmed and not run for more than 2 minutes (use a timer). But we really need more info.
.ERROR 403 - This is not the page you are looking for
Comment
-
I had just got it all done with an sss 3674 1300kv motor running a 40mm prop. Maiden run was gonna tape hatch after a quick cooling check and make sure no water was getting in through the drive. She ran perfect, ballanced but a little slow but safe at full speed n then bam she is stopped at an instant n sunk. Nose up but all submerged, lost hatch. There was a 5 gallon bucket under the water and I found it. Motor is smoking after I dried it out and tested it .everything else is good luckily because everything was brand new (esc, motor and power hd 20 kg digital servo) including complete everhaul of drive system upgradesComment
-
-
I buy some CNC Propellers here, 12 €uros each :
Comment
-
Graupner K carbon propellers are available here at OSE :
Comment
Comment