Uh-oh....look what I got in the mail today... IMG_1195.jpg It's ML's 9210.5 and it's going become the 2018 U-961564266_2398409523768009_5885496429916454912_o.jpg
Uh-oh....look what I got in the mail today... IMG_1195.jpg It's ML's 9210.5 and it's going become the 2018 U-961564266_2398409523768009_5885496429916454912_o.jpg
I am going to take the sponsons from the 9210.5 and stick them on the center section of ML's 203/9601 extreme kit....IMG_1197.jpg got to lower the top rear of the sponsons too....IMG_1198.jpg ...IMG_1199.jpg....IMG_1200.jpg
That's going to be a good looking boat. Can't wait to see it finished!
Vac-U-Tug Jr (13mph)
I love watching the start of a new build.
See the danger. THEN DO IT ANYWAY!!!
https://forums.offshoreelectrics.com/...hp?albumid=319
https://forums.offshoreelectrics.com/...hp?albumid=320
It's gonna be a bit before I really get rolling on this project, need to make a jig and I decided to trace out patterns and cut out the frames, instead of potentially destroying two good kits with some unforeseen problem: 48376745_1174778259343177_1309691186755141632_o.jpg IMG_1256.jpg 50077661_1196489333838736_696525283162849280_n.jpg
Nice day out. Got to watch the APBA Gold Cup...if it wasn't for that jumped start ...oh well. Got most my frames cut out and had some time today to start assembly those frames...IMG_1374.jpg IMG_1396.jpg IMG_1399.jpg IMG_1398.jpg
I can't decide if I should use the 1/16 ply i have in there already for the sponson air foils or cut it out and install 1.5mm carbon fiber sheet....IMG_1402.jpg IMG_1407.jpg IMG_1404.jpg
Use composites where ever you can they are stronger and more dimensionally stable. Composites don't need to be sealed and are easy to prep for paint. Do you plan on adding any lightening/drain holes to your bulkheads?
~~~~~~~~`Mach 5 racing'~~~~~~~~~~~~
****2008/9 MMEU LSO, 2008 LSH CHAMP****
~~~~~~~70 MPH Club Member!~~~~~~~~~
Ok, you convinced me. Just ordered some carbon fiber sheet. I think drain holes is a wonderful idea...got any pics on how you do that? As far as weight reduction holes in the bulk heads, I'm not gonna worry about it this time around. I'm just still learning how to build these things and at this point I'm just happy to have a boat in the water. If I get into serious competition I definitely will have to do that.
Ok, I received that carbon fiber sheet about a week ago, and today I had some time to cut out the wood, and cut out the carbon fiber sheet to fit test. I would say this was a good call K.R.Joye. now I can sand down the tops of the sponson stringers to shape, without them being in the way, And then just drop in those airfoils, after sheeting.IMG_1590.jpg IMG_1597.jpg IMG_1589.jpg IMG_1596.jpg
I had a nasty failure when I epoxied my cockpit onto the body...during curing (slow cure epoxy) the left side slid down an 1/8th....so this is on hold until I make up my mind on what to do about it...any ideas is welcome..
IMG_5460.jpg sooo much left to do and my boat shop is a complete mess.....I can't work in these conditions..lol
Beautiful
Vac-U-Tug Jr (13mph)
Very nice
Looking good
Bookmarks