Hello guys, acn you tell me if the procedure in the attached sheet is right or not?
Thank you so much!
prop drive setup.jpg
Hello guys, acn you tell me if the procedure in the attached sheet is right or not?
Thank you so much!
prop drive setup.jpg
HPR 115 kevlar bulletproof @90mph, MHZ Rapid carbonfiber, Bingo Race Minieco
Futaba AIR TX/RX system with telemetry
If I remember geometry correctly, that looks about right to me (not trying to be a smart @$$). But it has to be parallel with the flat surface below it to be 0 degrees. It does not matter what those 2 measurements are, just as long as they are the same it will be parallel.
Sent from my iPhone using Tapatalk
Bookmarks