Results 1 to 2 of 2

Thread: How to set drives at zero degrees

  1. #1
    Join Date
    May 2012
    Location
    IT
    Posts
    107

    Default How to set drives at zero degrees

    Hello guys, acn you tell me if the procedure in the attached sheet is right or not?
    Thank you so much!
    prop drive setup.jpg
    HPR 115 kevlar bulletproof @90mph, MHZ Rapid carbonfiber, Bingo Race Minieco
    Futaba AIR TX/RX system with telemetry

  2. #2
    Join Date
    Oct 2018
    Location
    FL
    Posts
    11

    Default

    If I remember geometry correctly, that looks about right to me (not trying to be a smart @$$). But it has to be parallel with the flat surface below it to be 0 degrees. It does not matter what those 2 measurements are, just as long as they are the same it will be parallel.


    Sent from my iPhone using Tapatalk

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •