Tppower 4070/1090kv performans

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Yakoo
    Member
    • Apr 2019
    • 36

    #1

    Tppower 4070/1090kv performans

    [B]tppower 4070/1090 KV do you think it helps the good motorm /B]
    Last edited by Yakoo; 04-17-2019, 10:07 PM.
  • Fluid
    Fast and Furious
    • Apr 2007
    • 8012

    #2
    What hull? What voltage? What use - zipzip, oval racing, sport running?


    .
    ERROR 403 - This is not the page you are looking for

    Comment

    • Yakoo
      Member
      • Apr 2019
      • 36

      #3
      mystic 138, 2x240a swordfish 2x4070 / 1090 kv and x457 think to use first trial 12s next stage 24s

      Comment

      • Nevs
        Sven
        • Sep 2011
        • 164

        #4
        A x457 is no problem on 6s..On 12s. I would not dear to start out with anything bigger then a x447.

        Comment

        • Yakoo
          Member
          • Apr 2019
          • 36

          #5
          I want to make the best selection of this engine I would like to go out at high speeds https://youtu.be/yfKXwAXhLTI contacted the owner of this video and said that it uses x457

          Comment

          • Fluid
            Fast and Furious
            • Apr 2007
            • 8012

            #6
            First off, this is a SAW setup not meant for extended running, is that what the OP really wants? While running those motors on 12S is at least possible for very limited SAW runs, 24s is not possible with the above setup. The motor will not survive for more than a few seconds, the ESCs even less. The OP needs to understand high voltage setups and not just copy what some else claims to have done. Otherwise he is doomed to expensive failure.

            Speeds in excess of 210 k/hr have been achieved on 10S in big catamarans, no need for 24S.

            .
            ERROR 403 - This is not the page you are looking for

            Comment

            • Yakoo
              Member
              • Apr 2019
              • 36

              #7
              [B]Well it is impossible to cancel the efficiency of these engines silaeis because the engine I have chosen is how good the speed can be./B]

              Comment

              • Mike W
                Senior Member
                • May 2018
                • 348

                #8
                Originally posted by Yakoo
                mystic 138, 2x240a swordfish 2x4070 / 1090 kv and x457 think to use first trial 12s next stage 24s
                I think you're confusing the terminology. 2x 6S/motor on a twin is 6S. Nobody runs 24S. 12S per side is still 12S.
                Otto RC Marine

                Comment

                • Yakoo
                  Member
                  • Apr 2019
                  • 36

                  #9
                  ok i understand that 12sx2 system crashes is 10x2 ideal battery right

                  Comment

                  • Mike W
                    Senior Member
                    • May 2018
                    • 348

                    #10
                    All of the components work together as a system. Your best bet is sticking with 12S if your eventual goal is 100+ mph speeds, but starting with smaller props.

                    The same boat that may only be good for a single pass on 457s followed by an immediate pumped-water cool-down may run 5 minutes on 452s.

                    Build your boat and work up to speed slowly.
                    Otto RC Marine

                    Comment

                    • Yakoo
                      Member
                      • Apr 2019
                      • 36

                      #11
                      Teşekkürler yavaş yavaş kurulum yapıyorum araştırarak yapmak istiyorum zaten en iyi performansi almak için daha ilerleyen zamanlarda resimler paylaşıcam

                      Comment

                      Working...