Azimut Atlantic Challenger

[vvviivvv]

So, since im getting back into the hobby, might as well get my original boat back operational.

I converted it to Brushless a few years back and burnt out the jet drive gear belt. these are impossible to find anymore so the boat never ran again....


Anyway, I ran it on Feiago 8XL's with my AS26-150 controllers...

My plan is to run it direct, I believe the impeller is 30mm I've done some searching and found some images of others that have been converted... I'd like to make a better job.

I think I'll try the 8XL's on 4s cheapo batteries for now with the AS26-150 and just be gentle with the throttle.

My question is, does anybody know of a flat motor mount that's fairly tall? the impeller shaft is 40mm high,
I'd like a tall version of this https://www.offshoreelectrics.com/pr...od=ose-80080-c

Plan B; Install 2 'runners' - carbon square tube and mount the motor mount onto of this.


Will need some couplings... and it to line up perfectly, I've seen some people using rubber couplings maybe this is a good idea...?