I made a search but nothing, do you know this hull ? I don' t know the brand
I made a search but nothing, do you know this hull ? I don' t know the brand
Where did you find the photo? What size is it?
A nation of sheep breeds a government of wolves
It appears to be one that is sold by DYMotorshop. It’s 75 cm long and has lots of lift. Probably not the best for high speeds.
http://www.dymotorshop.com/index.php...roducts_id=463
.
ERROR 403 - This is not the page you are looking for
'' and has lots of lift ''
Where did you read that ?
https://www.ebay.com/itm/750mm-29-5-...4AAOSwkZhWRUML
I'm sure Fluid can simply look at the bottom of a hull and just know that from experience.
A nation of sheep breeds a government of wolves
Yes, this hull is a Deep Vee, not a flat V.
Look at MHZ hulls, they are Deep Vee. The COG must be near 28%, no turn fins needed.
Center strakes right to the transom. It's going to ride high on the keel with almost nothing in the water. Small rudder input and it will lay over into a tight radius. Fine at low speed where you can maybe carve it out but at high speed.......sketchy. Likely will hook or tumble. Just my opinion from running similar strakes.
There's some video on youtube of one of these. Can't remember who had posted it.
Noisy person
I think jessej had one of these....
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
Strakes are no big deal in modding the strakes. Just find a boat of same size and grind off the strakes if you really love the looks of boat. Just fill in and paint and then cover with CA and sand. Make sure you make mod, same as the boat of same size.
I went looking for thread under carbon hull and different names but came up empty.
I remember this thread about the TFL integrated drive he installed in that hull: https://forums.offshoreelectrics.com...ono&highlight=
Vac-U-Tug Jr (13mph)
Bookmarks