Have a bet coming up this summer (another thread)
Anyways: setting this thing up (Carbon Zonda 41" twins) 180amp seaking ESC's, sss2075kv motors, upgraded cooling, upgraded rudder, 5.5mm bullets (ESC-motors) ABC-1716 Dashbota props, 12s (6s each side, 5200Mah/70c) (Know 12s is going to be hot)
He upped the bet to 500. He has a regular weed whacker motor that he found in the trash and installed a some 50" mono (from the trash he found)
Will EC5's connectors batteries to ESC be enough? Just all my 6s batteries are with EC5's. Granted this will just be for a few saw runs (and maybe to show off once in a while) other than that I'll use 8s (4s per side) I'm thinking just change them all out to 6mm or 6.5mm. All I have is time on my hands right now.
One other thing, (not sure If I'm going to use the right wordage) somewhere on here I found where someone posted on how to hook up the batteries so that each ESC gets voltage from each battery, therefore batteries get drained equally (if you understand what I'm saying) been looking/searching for hrs this past week.
Doing all the reinforcements this week (as soon as my drug buddy lets me use his scale to measure resin)
My word: on checking the motors out one of them, when I move the shaft side to side there is a bit play (I here tick/tick/tick) cannot measure distance of play though, to little (bearings shot?)
Enjoy the summer, it will be short,
John
Bookmarks