Hi all im using a Seaking 120 amp esc the old flat version from 6 yrs ago . The unit stopped working and upon carefull inspection i noticed the 2 end capacitors one looked deformed the other looked like it dumped a gooey substance that looked like half dried epoxy . I unsoldered the 2 capacitors having been labelled 35 v 390 micfofarad and off i went to the local electronics supplier the nearest capacitors they had where 63v 470 microfarad the guy said this should work ! I work in the process piping industry and not having a lot of electronics experience. Would it be correct to solder these capacitors to replace the other ones with out the danger of destroying lipo's or motor or the esc ? Regards Andris Golts.