Speed junkie here checking in, I don't seem to care about anything else.
I would like the RC to run down to the starting point of the run, make a full speed pass and drive back to me.

In this scenario of a 10 sec run, not taking into account the application, weight, load etc.... What would be the harm in going double the KV from the "norm" of low 800-1300 kv on 8s. To something like a D wind 2600-3200 kv in a 58 series motor.

My thoughts are that Higher KV motors can do more with each volt. Heat is the obvious concern, but I feel that a 10sec run the motor will likely survive. Data logs show my 33V runs drop to as low as 25V under load at 320+ amps.

For now the system is 8s in the 300-400 amp range.

Thanks in advance for any help/advice.

-Liberty